AmateurRadio.com

What is one supposed to do with the BNC connector pictured right?

I ordered 5x Crimp On BNC Plugs from eBay, expecting to get plugs with a narrow body and separate small piece of tube that you use to crimp the braid of the cable to the body of the plug. What I actually got was these, which I already had a couple of and didn’t know how to use. The only way I can see that you could use these is to crimp the large diameter barrel on to the braid itself, but with nothing but the nylon insulation beneath it you are not going to get a good contact. I think they are useless, though I did make a QRPP dummy load from one of the originals as two 1/4W 100 ohm resistors in parallel just fit inside the body of the plug and you can solder the ground ends to the outer.

I guess soldering the braid is the answer, but that isn’t what I bought crimp on plugs for and it isn’t going to make a very neat job.

I noticed today that the PI9CAM group who use a huge 25m diameter dish for 1296MHz moonbounce would be active. The great thing about these guys is that you can listen to their receiver using a WEBSDR receiver at http://websdr.camras.nl:8901/

I took a very quick video – which isn’t great quality, but you’ll hear PI9CAM working a JA station. Remember the signals are bounced off the moon – a round trip around around 500,000 miles! You get a demonstration of the speed that radio signals travel at (the speed of light!) by listening to the echo from PI9CAM. You’ll hear him stop transmitting and then after a pause, you’ll hear the echo as it comes back from the moon.

A lot of EME takes place using the WSJT modes, but the contact on the video is in SSB – testament to the great equipment in use at PI9CAM! As I write this, I’m listening to LX1DB on SSB too – so I highly recommend you have a listen next time the group is active – check their webpage for details.

Series Four Episode Two of the ICQ Amateur / Ham Radio Podcast. News Stories include:

• Commemorative stamps for radio society
• UK antenna manufacturer launches
• International Short Wave League celebrations
• Radio Meteor Detection
• Amateur Radio Club helps kids communicate
• UK DRM+ trial
• Italian amateur radio repeaters disregard IARU bandplan
• New UK lightwave record
• 8 year-old Arkansas Radio Ham

Your feedback and Colin (M6BOY) reviews taking part in the Irish 80m contest.

Finally got all of the SoftRock downconverters here enclosed and repaired.  Turns out I managed to cross two of the wires on the input transformer of my 20-meter v6.2 Lite (“upgraded” variant).  Once I found that, it sprung to life.  The other project was getting the 144-MHz Ensemble II VHF into an enclosure.  This has been a long-standing struggle since the nearest size diecast box is just a hair too small.  So, I put it into an extruded aluminum enclosure I found at Dayton a few years ago.  Unfortunately, I had to make my own front and rear panels.  But, I had an old minibox that was perfect for the donor material.

I should have polished the edges of the front and rear panels, but it’s not too bad.  KK7B opined in a QST article many years ago that after homebrewing “about 50 enclosures, they start to look respectable.”

Holes were punched with a hand punch from Harbor Freight.  Given the cost of the Roper-Whitney equivalent and for as much as I will use it, this is perfectly acceptable.  There’s nothing like having the right tool for the job!  However, mine came with two 5/16-inch punches (no 1/4-inch), but one each 1/4-inch and 5/16-inch die.  Ooops.  VFBBYQC.  So, I had to drill the 1/4-inch LED hole.  A nibbling tool made quick work of the USB cut-out.  I cut the panels with hand shears.  So, I guess it should be clear what’s next on my sheetmetal shopping list…

Now, I need to actually play with some “real” SDR instead of just diddling around with Rocky (which is very capable).  I’m running it under Windows XP on a 1.3 GHz Pentium IV with 1 GB of RAM.  The sound card is a Creative Labs Audigy 2 ZS.  There is a little latency when running a large waterfall and resizing windows, but it’s adequate for tinkering.  Eventually, I’d like to try some of the GNU/Linux SDR engines.  But, I’m just going to wait until a new (to me) computer falls into my lap before that happens.

Some of you may have noticed that I haven’t published anything here for a bit over a month. I was also pretty much absent from several of the other “social web” places that I frequent (Facebook, Twitter, etc.) and in fact got a couple of private notes asking if everything was OK. (Thanks to those who asked for your concern.) The short version is that everything is just fine. Here’s the longer version:

Around a week after I published my last update, I managed to come down with a kidney stone just about a year after the last time I had one. I’ll skip the details, but suffice it to say that I wasn’t very comfortable for a while and blogging, ham radio, and pretty much everything else not essential to feeling better got put aside. Complicating things was the fact that along with Sharon, Justin, and Brett, I was supposed to leave for vacation on the evening of December 25th, and the doctor was pretty adamant that I shouldn’t be traveling unless I had passed the stone. Fortunately, it did pass just a couple of days before that, and given everything we had to do before leaving I never had time to do an update.

The trip itself was something we’d planned for a long, long time, figuring that with the kids getting older (they are both in college), it would become increasingly difficult for all of us to get away. Our trip started in Barcelona where we spend three days sightseeing followed by a twelve-day Mediterranean cruise with stops in Palermo, Athens, Rhodes, Alexandria/Cairo, and Malta. I’m not going to go into detail here about the trip, but I did want to post a couple of pictures that are on topic for this blog.

First, as we were driving from Cairo to the pyramids in Giza, I looked out the window of the bus and saw this antenna. Actually, although I didn’t notice it at the time, in addition to the beam that’s right in the middle of the picture, there’s also what appears to be a wire dipole just to the right of that. Unfortunately, I don’t know specifically where this picture was taken other than we were in Cairo at the time, so I don’t know who that might belong to. (Any Egyptian hams reading this?)

I know exactly who the next antenna belongs to: The Malta Amateur Radio League.  I know this because just a second or two before I took this picture, we passed a big sign that said “Malta Amateur Radio League”. Unfortunately, we were on a bus driving from the city of Mdina to the capital city of Valleta, so I couldn’t stop to get a picture of the sign, but I did get a picture of the antenna on the roof of their building. I apologize for the lousy picture but I’m glad that I was able to even get this shot before we had completely driven past. We only had six hours in Malta, so I didn’t have a chance to try to get back to the MARL shack to see if there was anyone around, but I can say that Malta was absolutely beautiful and I hope to get back there some day for a longer visit.

I guess I should mention that I didn’t do any ham radio while we were away at all. We had a very tight schedule almost everywhere other than some very relaxing days at sea, and given the difficulties of transporting gear with me (in addition to everything else we brought), licensing, and the fact that unfortunately Royal Caribbean Cruise Lines explicitly prohibits the use of ham radio on board the ship, I decided that it didn’t make much sense to try to operate. As a result, it was just over a month between the last HF contact I made in December (before I was ill), and the next one that I made in January after I returned.

Some of you may have noticed that I haven’t published anything here for a bit over a month. I was also pretty much absent from several of the other “social web” places that I frequent (Facebook, Twitter, etc.) and in fact got a couple of private notes asking if everything was OK. (Thanks to those who asked for your concern.) The short version is that everything is just fine. Here’s the longer version:

Around a week after I published my last update, I managed to come down with a kidney stone just about a year after the last time I had one. I’ll skip the details, but suffice it to say that I wasn’t very comfortable for a while and blogging, ham radio, and pretty much everything else not essential to feeling better got put aside. Complicating things was the fact that along with Sharon, Justin, and Brett, I was supposed to leave for vacation on the evening of December 25th, and the doctor was pretty adamant that I shouldn’t be traveling unless I had passed the stone. Fortunately, it did pass just a couple of days before that, and given everything we had to do before leaving I never had time to do an update.

The trip itself was something we’d planned for a long, long time, figuring that with the kids getting older (they are both in college), it would become increasingly difficult for all of us to get away. Our trip started in Barcelona where we spend three days sightseeing followed by a twelve-day Mediterranean cruise with stops in Palermo, Athens, Rhodes, Alexandria/Cairo, and Malta. I’m not going to go into detail here about the trip, but I did want to post a couple of pictures that are on topic for this blog.

First, as we were driving from Cairo to the pyramids in Giza, I looked out the window of the bus and saw this antenna. Actually, although I didn’t notice it at the time, in addition to the beam that’s right in the middle of the picture, there’s also what appears to be a wire dipole just to the right of that. Unfortunately, I don’t know specifically where this picture was taken other than we were in Cairo at the time, so I don’t know who that might belong to. (Any Egyptian hams reading this?)

I know exactly who the next antenna belongs to: The Malta Amateur Radio League.  I know this because just a second or two before I took this picture, we passed a big sign that said “Malta Amateur Radio League”. Unfortunately, we were on a bus driving from the city of Mdina to the capital city of Valleta, so I couldn’t stop to get a picture of the sign, but I did get a picture of the antenna on the roof of their building. I apologize for the lousy picture but I’m glad that I was able to even get this shot before we had completely driven past. We only had six hours in Malta, so I didn’t have a chance to try to get back to the MARL shack to see if there was anyone around, but I can say that Malta was absolutely beautiful and I hope to get back there some day for a longer visit.

I guess I should mention that I didn’t do any ham radio while we were away at all. We had a very tight schedule almost everywhere other than some very relaxing days at sea, and given the difficulties of transporting gear with me (in addition to everything else we brought), licensing, and the fact that unfortunately Royal Caribbean Cruise Lines explicitly prohibits the use of ham radio on board the ship, I decided that it didn’t make much sense to try to operate. As a result, it was just over a month between the last HF contact I made in December (before I was ill), and the next one that I made in January after I returned.

Since I discovered the Graves transmitter on 143.049 a week or so ago, I have been listening quite a lot. There are plenty of meteor reflections to listen to and it’s also interesting to note that there are some weak but steady signals audible in addition to the meteor reflections. My guess is that these are reflections from aircraft – after all there are plenty in the air between here and Dijon.

Today, I installed the Easygram software on my laptop. I have used this software previously for beacon monitoring and other analysis. I quickly configured up the software and was able to see consistent traces from the transmitter. I can’t see any evidence of Doppler shift on the ‘steady, constant’ signal, which I would expect to see if an aircraft was involved – so perhaps it is tropo after all (Having said all of that, I am listening to the transmitter whilst writing this, and I can distinctly hear aircraft scatter on it!).

Here’s an example of an image from Easygram which shows a meteor ping from the transmitter. If you look closely at the image, there is a faint trace line towards the centre of the screen – this is the weak, steady signal, probably the tropo signal from the transmitter.

Here is the location of the transmitter shown on Google Maps

View Larger Map