A brief overview of my MFJ 1788 loop antenna.

The antenna
Overall I have been very pleased with the purchase of the MFJ 1788 loop antenna. Considering the location I am in and the restrictions of a condo such as.....concrete all around you, other buildings blocking your signal, very small space to put an antenna and power level must be kept low as to not affect the neighbors. After doing considerable searching for the right antenna for this location it boiled down to this antenna. The power I run is 5 watts max and this is not new for me as I have been a QRP op for years now. Below are the reasons why I am pleased with this antenna to be followed by some of the not pleasing things about the antenna.
1. Very small foot print for an antenna that will give you 15m to 40m.
2. The antenna can be used mounted horizontally or vertically.
3. Once you get used to the tuning it's very fast and easy to tune.
4. I covered my antenna with as to keep it low profile and it works no problem with the cover.
5. The antenna remote control can operate either on AC or batteries.
6. Can be mounted on a simple tri-pod.

Some of the draw backs
1. The quality of the antenna is low, I had to make some adjustments to make it work as it should.
2. The band width is narrow and retuning has to be down often.
3. The SWR meter in the remote control unit is not very reliable.
4. Buzzer used to tell you the coarse tuning has finished is VERY hard to hear.
Repairing Cap spacing

On air results with this antenna have been good, with regards to receiving I have been able to hear the Middle East, South Pacific, Europe, South America and of coarse North America. Now hearing a station and contacting the station is another ball of wax. With my power restrictions I have made some very satisfying contacts. My modest signal has made it into South America, all parts of Europe, Iceland and Africa so far. There are two Loop antennas that MFJ makes and if I was to make the choice again I would had gone with the MFJ 1786 as it covers 10m to 30m. I have found with this antenna there is no way to tune it below 15m. The characteristic of the tuning capacitor will not allow it. I have read the MFJ 1788 is like a wet noodle on 40m and it's true I have not been able to make it into the U.S. The MFJ 1786 would had been a better choice with more band opportunities.   

What’s up with Microsoft Hotmail?

I have a Hotmail email account and have had it for some time now but over the past 6 months or so I am continually asked about security codes and it makes logging into my account a real problem. I really don' t want to delete this account as there are so many who email me to this account as well most if not all of my ham radio messages are handled via this Hotmail account. This evening I was once again logging into my email account and now Microsoft is demanding I have them send a "code" to me and it has to be done through a different email account. I do have another account that I use now and then (Gmail) but what about those who do not! What…….you have to open another email account just so Microsoft can email a "code" that you cut and past into you hotmail account so you can prove you are who you say you are!!!
I had the Hotmail cop's send me a "code" to my Gmail account and was told it was sent, well when I opened up my Gmail there was no "code" just a link so I clicked on the link. I was taken to a page that asked me to enter my Hotmail account that I was trying to verify. I thought I am in the home stretch so I entered my long time Hotmail account and was told "We're not ready for you yet, your account is still in the waiting period."  WAITING PERIOD FOR WHAT!!!
When you move to a new address you can get the post office to forward your mail is there anything out there that allows my Hotmail emails to be forwarded to my Gmail account.?I have had it with Microsoft and the "code" they want to send me so I can let them know I am who I say I am!!

The Yaesu FT-897 is coming to it’s end

I read the report on Southgate Amateur radio news that the Yaesu FT-897 is coming to an end. This is a great rig for both portable, mobile and home use. You can have up to 20 watts on battery power and up to 100 watts from  your DC power supply. Not only do you get HF but VHF and UHF as well. This rig being an all in one was just great to the new ham who can't afford the large price tag with some of the larger rigs but with features that this radio comes with. There is no news from Yaesu as of yet of a replacement or even if there is going to be one.

It’s radio time but no one is there!

Me and my son 22 years ago
We have our relatives over from jolly old England so it has been very little radio (until today) and all showing the sights of Toronto. It has been a blast showing off our city and seeing and hearing the excitement about places we take for granted. Today we had a "rest" day so once the house chores were done it was RADIO TIME!!! I flipped the switch on around 1pm local time and the bands were dead out this way. I checked the solar data and it was not good but that did not stop me from checking the bands! In the past I have found that even when they say the conditions are poor I have still been able to make some decent contacts. This time around it was not the case at all so I did get the thrill of spinning the the VFO as for a contact.....not so much. It was then time to blog about my none contact day.

A Friday evening nets some DX contacts.

On Friday evening I was able to pull some radio time out of my hat and it was time to try my MFJ 1788 loop antenna on 17m. I was very happy with the results it was very easy to tune (SWR of 1.2.1) and the band width was decent so retuning was not needed most of the time. I operate QRP at 5 watts so having the antenna on the balcony, it also being a small loop antenna plus QRP it's a bonus when I contact some DX.  I first heard S59AA calling CQ at 18.078 and my first attempt was not heard and another station jumped in and made his contact. I threw my call in again and I was heard and given a 559 signal report.  Franc was located in Slovenia and was operating an Elecraft K3 he was also booming in. The time was 5pm local time and 17m seemed to be wide open to Europe so I decided to spin the dial and see what else the ham god's brought my way. I then made contact with HB9CVQ in Switzerland, again another bonus for my ham setup. I was given another 559 RST but again I am just fine with that. I emailed both S59AA and HB9CVQ to give them a  little more details of my station but most of all to thank them for sticking with me and passing along a 559 signal report. I did hear back from Andy HB9CVQ who passed along some info about his station as well and it too included an Elecraft K3 radio . I try to avoid using the spotting clusters as for this tiny station hopping over to a busy spot just does not end well. I did spin the dial for a final time and I came across KH2L in Guam! In the past I had tried to make contact with Edward as he booms into here and I was not able too. Friday was no different I dropped my call but it was not heard by KH2L.....oh well. It's now Saturday afternoon and the bands are in so so condition I ended up spending time writing this post with the radio cans on.

Hat’s off to Palm Radio!

When I came home from work today there was a package in the mail for me, now this is not an unusual thing but I never ordered anything!! Holding the package and making my way back up to my condo apt I am old and do forget things but I was very sure I did not order anything. I opened the package and out came a very nice QSL card from DK7SN, DL9SCO and DL2BAT all hams from Palm Radio in Germany.  I have used their Palm paddle for years and without a doubt this is one of the best paddles I have ever used! I have used it with my Elecract KX1, K2 and KX3 radios and for those CW op's out there you understand when I say it's very smooth, adjustable to your fist and the dit's and dah's you ask of it are the only ones given to you….no more no less. Those of you out there that hit the trails (now that the summer is here) and are looking for not only a portable key but one that is compact and reliable the Palm needs to be seriously considered! It seems I have gone off on a tangent here and wondered away from the package I received.........it seems that the gents at Palm radio read my blog and read a comment I made about their cable that connects the Palm paddle to the rig. I said that it seemed it could become damaged easily and for that reason with my KX1 I made the cable attachment permanent. Well HAT'S OFF TO PALM RADIO the cable has been re-designed and  they sent me the new cable free of charge! What they improvements have been made you ask……..
Old cable on KX1
1. The new cable is thinner.
2. The new cable is more flexible.
3. The 3 pin connector ( the area of concern for me) now has an integrated strain relief.
4. The strain relief 3 pin plug is available on it's own so you can use your own cable to suit length.
5. A 3.5mm gold plated plug is added for a more reliable connection.
The new cable
All the new Palm Paddles I am informed now ship with this new cable. Julie and I on many occasions have had a conversation about success in business. Seems we have always come back to the same conclusion over and over again and that is CUSTOMER SERVICE! As hams we all know the companies that offer over the top customer service and those that fall short, it's not my place to mention those that fall short........Some of the companies that I have dealt with that offer fantastic customer service are Elecraft, DX engineering, N4PY software,Telepost, Alexloop, Begali keys and  A&A Engineering this is not an exhaustive list but the companies I have dealt with and had over the top service. Also added to the list is Palm paddles!




   

Sunday evening on the radio

This weekend brought great weather and so it was out and about with Julie, but I did find some time for radio on Sunday evening. The bands were busy with contests and not wanting to get involved with them I skipped up to the QRP watering hole on 20m. I started calling CQ as I could not hear to much action. In a very short time W5TM came back to me and I was only 449 but it was a contact and that was good enough for me! Our QSO did not last to long as I was very much in and out I did send Edwin an email thanking him for the QSO. During my next CQ calling a G station came back to me but they were down in the mud. I switch on the APF and we did try over and over again to make contact but things just did not work out. It was pretty cool that my QRP signal was somewhat making it into "G" land. My last contact for the evening was with KA5KMS and this was a long QSO with a solid contact at both ends. Terry was running a Ten Tec Century 21at 25 watts into a dipole.  It was a good evening on the radio! They all were short QSO's but it will help keep me in the hobby, keep my code up and help me become more and more aquatinted with my rig. I have found that I can easily get lost in my ham programs, antenna issues and PC hiccups that involve radio. Bottom line it's great to put all that to the side and get on the radio and make some good old contacts.

Subscribe FREE to AmateurRadio.com's
Amateur Radio Newsletter

 
We never share your e-mail address.


Do you like to write?
Interesting project to share?
Helpful tips and ideas for other hams?

Submit an article and we will review it for publication on AmateurRadio.com!

Have a ham radio product or service?
Consider advertising on our site.

Are you a reporter covering ham radio?
Find ham radio experts for your story.

How to Set Up a Ham Radio Blog
Get started in less than 15 minutes!


  • Matt W1MST, Managing Editor