AmateurRadio.com

If you haven’t read Part I , Part II and Part III first, you might want to do that.

As I mentioned previously, once I got the power problem figured out I was able to easily make contacts with other stations, which is what I’d planned to do in the first place. In the first half-hour of operating, I made contact with about 25 stations. Compared to rare DX stations this is very slow, but my operation was very low-key and I’d often spend a bit of time to briefly chat with the other operators, so this was far from the typical “K2DBK you are 59 thanks QR Zed” that you hear in those operations. I was having a great time working stations, and after a while I started to hear folks in Europe calling me, but they were covered up by the US callers. I figured that I’d try to work as many folks outside North America as I could, so I asked for only stations outside of North America, and worked 9 stations in as many minutes, all outside the US. I worked folks in Italy, Poland, Spain, and Belarus all in fairly quick succession. Thanks very much to the folks in North America who very politely stood by while I worked the other stations. Not one single person from North America called when I was asking for the other folks. (By way of explanation, it is an unfortunate fact of life that all-too-often hams will “call out of turn” and ignore requests from contacts from specific areas. When they do that, it just slows down the process.)


After I had contacted the folks outside North America, I went back to working any station that was calling me, and I picked up a mix of both US stations and some more DX from Italy, Serbia, and Belgium. I had a couple of other chats during a few lulls with Larry, KH6ITY, and finally shut down for the day at around 4:45PM local time to head back to have dinner with the Sharon in St. Armands.

The Legendary Salty Dog

The following day I got somewhat of a later start than expected, but I did want to stop at The Old Salty Dog again, this time to have what is one of the most delicious and presumably most unhealthy foods in existence: Their signature “Salty Dog”. A Salty Dog is a jumbo hot dog dipped in beer batter and deep fried. It is indescribably delicious. Of course, it must be washed down with a nice cold bevarage (a Bass Ale for me, thanks). 


When I arrived at the park, the parking spot I’d had the first day was taken, and I was having trouble finding a place to park where I could be close enough to be able to set up on a picnic table, but as I was walking around (I’d parked temporarily “out of range”) someone left and I was able to pull in close to a different table, this time right out in the sun. The only downside to this location was there there wasn’t another table nearby so that I could set up the antenna on a different table, but I was able to set up the antenna on one end of the table and operate from the other without any issues.  Well, not at first.

Buddistick set up for 20m with counterpoise thrown over a tree branch

I started off working stations on 20 meters and worked a number of US and Canadian stations, as well as a station from Slovakia and one from Hungary. I’d been trying to set up a contact with Scott, NE1RD, who was now operating from the island of St. Thomas (as KP2/NE1RD) on and off for a while by this point. I emailed Scott from my BlackBerry that I was currently on 14.260Mhz and Scott quickly threw together an antenna for 20m, but by the time he got on the air, I’d lost the frequency that I was using and we didn’t make the contact. “Losing” the frequency means that I was using it to make contacts, but due to the way that propagation works, sometimes two (or more) stations will be using the same frequency, both unable to hear each other until the conditions change, then usually one of the stations will wind up “taking over” the frequency. This is what happened in my case, and I “lost”.


As it turned out, Scott had already built a 2 element beam for 15 meters using the Buddipole gear that he’d brought, which would provide a much better signal to me. I reconfigured my antenna for 15m (very easy to do), and coordinating once again via email we were able to contact each other. Neither Scott nor I consider ourselves as “rag-chewers”, which are folks who prefer to get on the radio and have a nice long chat with someone. I’ve certainly done that in the past, but most of my current interest is in working DX stations and contesting, both of which  require very brief, specific exchanges of information. However, Scott and I found that we had a lot to talk about, so the contact was not a brief one. About 10 or 15 minutes into our conversation, I got another visit from Mr. Murphy.


As we were talking on the radio, I thought that I noticed the odd sound in my headset that I’d heard previously. This didn’t make any sense, since the car was still running (as you’ll recall, the battery alone was unable to provide sufficient power to transmit at full power). Scott then commented that he could hear my signal starting to distort, so it sounded like the problem was returning. We both tried to figure out what might be going wrong, and while trying to figure out what could have “broken” while operating (nothing had been touched since I originally got on the air that day), I thought that perhaps our relatively long chat had caused the power cables to heat, which in turn would increase the resistance in the cables, reducing the power available to the radio. I felt along the length of the cable but didn’t feel any warm spots. I was about to rule out the wire heating up when I realized that I’d closed the hood on the car almost all the way and when I opened it, obviously (in hindsight) the portion of the power cable that was closest to the battery, and under the hood, was quite warm. It hadn’t heated up solely from transmitting, but also because it was a warm day and with the engine running and the hood closed, the engine compartment was quite hot. The solution to the problem was now quite simple: Leave the hood of the car open.


After just a minute or two, the power cables cooled enough to allow enough power to flow so that my radio was again transmitting normally. Scott and I finished our chat, and I decided to stay on 15m where I worked stations from Puerto Rico, Italy, Portugal, and the US, finally finishing up with a nice chat with Andy, AE6Y who was operating from Aruba as P49Y, having just arrived there prior to the WPX Contest that was coming up. When I finished with Andy, it was time to shut the station down to head back for a final family dinner, since we were leaving for home the next day.


In all, despite losing a day of operating due to the power problem, I would rate this as a successful operation for a number of reasons. First, I did finally get on the air and made contact with 16 different DXCC entities (countries) and at least 10 different states. (It was almost certainly more than that, but I didn’t always get the name of the state for the station that I was talking to.) Second, I was able to give back a bit to the hobby by talking to, and with Larry, KH6ITY’s class. If even one of his students goes on to get his ham license that would really be a wonderful extra benefit. Third, I’ve made a number of new friends both as the result of both my operation on the air and the attempts to troubleshoot with the wonderful folks from the Buddipole Users Group. Fourth, I’ve learned a bit more than I already knew about troubleshooting this type of problem. Finally, and perhaps most important, despite the issues that I ran into, I had a really good time doing this.


I have really enjoyed writing this series, and I want to thank those of you who’ve commented about how you’ve enjoyed it as well. There is a bit more information that I want to share that I’m going to write as an epilogue to this series, please look for that soon.


Until then,
73,
David, K2DBK

Update: I’ve posted the epilogue.

David Kozinn, K2DBK, is a regular contributor to AmateurRadio.com and writes from New Jersey, USA. Contact him at [email protected].

Look out Hontoon Island the Polar Bear of Florida is coming your way! Good Friday, 2 April 2010 Polar Bear QRP member #173 (aka K4UPG) will attempt to qualify Hontoon Island as a US Island on the Air by making 25 contacts including at least 2 DXCC entities.

Activity will start about 1400Z after the ferry ride over to the island. Plan is to use special callsign K4T for recognition.

Look for us on 30m cw (10.106-10.116 MHz) and 20m cw 14.050-14.070 MHz and on the hour we will check 15m 21.060-21.070. If anyone shows up to assist, will also attempt ssb on 14.250-14.260 MHz island corridor. All ops will be QRP so we’ll need your help to pull us out!

***************************************************************************************

If things go well, our Central Florida QRP group may consider this as a new operating site! If you are in the area, come on and check it out with us.

Thanks to Florida State Parks for the fine pictures!

P.S. We did it 4.2.2010!  Over 30 QSO’s update coming! I am TIRED!

Kelly McClelland, K4UPG, is a regular contributor to AmateurRadio.com and writes from Florida, USA. Contact him at [email protected].

A QRP record was shattered this week when Bob Goblosovits, W9RJX, after making a contact on 40 meters with a homebrew QRP rig in a tunafish can using 1 watt into a dipole, exclaimed on the QRP-L reflector "QRP really works!".  This was the 239th time Goblosovits made the claim on a reflector, beating out Algernon Smith, WB2ACH, who previously held the record at 238 reflector messages in his ham career.  Smith unfortunately passed away last year after succumbing to a heart attack at his workbench while soldering a surface mount kit rig.

It's expected that Goblosovits will be nominated and inducted into the QRP Hall of Fame this year at Dayton.
Anthony Good, K3NG, is a regular contributor to AmateurRadio.com and writes from Pennsylvania, USA. Contact him at [email protected].

Last year, through the efforts of a fried of mine, I was able to talk to Red Hot Chili Pepper's lead vocalist, Anthony Kiedis, and bassist Mike Balzary (better known as Flea) about Amateur Radio. It hasn't been reported often, but both Anthony and Flea are hams and in between tours operate out of their California homes. We stopped over at Flea's house. In the driveway he points out his self-supporting 200 foot tower.

"I've got it loaded up for 160...the whole tower. Radials all over the [expletive] place. Damn thing was hell to put up!" he said.

Kiedis and Flea laugh as we walk inside. Flea's living room filled with old tube gear of every kind and parts are lying everywhere on tables, shelves and the floor. Amid the mess, various Hallicrafters, Collins, and Drake rigs can be seen, though Flea's affinity for Johnson equipment is obvious as it dominates the landscape.

"I love AM. A bunch of wankers told me AM was old and too wide on the band. I told 'em to [expletive] off and I went to AM and never looked back."

Flea takes us into a back room. A four bay Gates AM transmitter graces the room which is amazingly spotless in contrast with the previous room. Flea flips on a huge breaker mounted to a piece of plywood on the wall and the beast comes to life and a deafening roar of fans and tube air blowers fills the room. We go into the next room which is soundproof and contains his operating position with a mixing board and a high-end Heil microphone on a boom.

Kiedes explains that he currently doesn't have a station, though he often comes over to Flea's shack on the weekend and operates while having a few beers and grilling steaks.

(This is a brief excerpt from my upcoming book, Unknown and Undercover Amateur Radio, due out in September from Simon & Shuster.. )
Anthony Good, K3NG, is a regular contributor to AmateurRadio.com and writes from Pennsylvania, USA. Contact him at [email protected].

Today Pope Benedict XVI announced in Rome that Morse code proficiency has been added to the requirements for being considered for recognition as a saint.  In a brief statement the Pope said:

"It has been known throughout the ages that knowing and using Morse code makes one a more whole person.  We today officially make it a requirement of canonization....one must know the code to be recognized a saint."

The move was applauded by millions in countries throughout the world.  "This should keep the quality of saints high" noted one blogger in France.  One person interviewed in Times Square in New York City exclaimed "It's about time.  This should keep the riff-raff out of sainthood.  Several hundred years ago you had to perform real miracles to become a saint.  Today you can just feed a few million starving people and, like, instantly you're considered for sainthood.  Having to know Morse code will finally raise the standards back to where they need to be."
Anthony Good, K3NG, is a regular contributor to AmateurRadio.com and writes from Pennsylvania, USA. Contact him at [email protected].

A new posting by Dan KB6NU alerted me to the fact that eHam.net is now allowing users to rate ham radio blogs. I followed his link, selected the Blogs category and found that of all the blogs currently rated, G4ILO’s Blog is (or was, when I went there just now) the only blog that had a rating of five stars! I am amazed, humbled and proud, even if only two people had actually contributed to the rating. 🙂

If you would like to help keep my blog at the top of the table, please pop over to eHam, click on the stars next to G4ILO’s blog and add your rating and comment. Thanks!

Julian Moss, G4ILO, is a regular contributor to AmateurRadio.com and writes from Cumbria, England. Contact him at [email protected].

With the growing popularity of ham radio simulations like QSONet and HamSphere, I guess it had to happen sooner or later. According to an announcement just out on the IARU website, from today contacts made using these VOIP systems are now officially amateur radio contacts and can count towards amateur radio awards.

The announcement says: “There is an ever increasing use of computer and internet technology to facilitate the making of contacts between amateur radio operators. For many years use of the DX Cluster has been permitted to locate DX contacts to work and many operators now use internet sites to arrange skeds for needed contacts. We also see the development of new digital modes that can make possible contacts between stations that neither side can even hear. Permitting the use of VOIP modes to make contacts is simply an extension of the use of this facilitating technology, by removing the unreliability caused by the behaviour of the ionosphere. This move will also be welcomed by the many radio amateurs living in antenna-restricted locations who are no longer able to be active on what have traditionally been regarded as ‘the airwaves’.”

Addressing the criticism that no radio is actually used when making contacts via QSONet or HamSphere, the statement says: “Many amateur operators nowadays use laptop computers which are connected to the internet via a wi-fi router. This does, of course, involve the use of radio. Initially, therefore, only contacts made using a laptop with a wireless connection will be allowed to count under this new ruling. The frequency should be logged as 2.4GHz. This restriction will be reviewed at a later date.”

More information on this development will apparently be posted on the site at midday today.

Julian Moss, G4ILO, is a regular contributor to AmateurRadio.com and writes from Cumbria, England. Contact him at [email protected].