W5OLF WSPR kit

Jay has been working on new versions of his little WSPR beacons. All being well I should receive a 10m 500mW out version in the next few weeks.

Jay is writing the manual(s) and has asked me for my feedback, which I shall, of course, provide. The new version is a single board (again) but transmits continuously, randomising the TX frequency on each TX burst to minimise interference to/from others. It needs several minutes to thermally stabilise but uses the uP to generate everything needed such as the WSPR tones, so no PC is needed. The transmission is started manually on the start of an even minute with a push button. The PA can be separately enabled.

This should be fun. I’ll give more information when it arrives and I get a chance to try it on the air.

Roger Lapthorn, G3XBM, is a regular contributor to AmateurRadio.com and writes from Cambridge, England.

One Response to “W5OLF WSPR kit”

Leave a Comment

Subscribe FREE to AmateurRadio.com's
Amateur Radio Newsletter
News, Opinion, Giveaways & More!

E-mail 
Join over 7,000 subscribers!
We never share your e-mail address.



Also available via RSS feed, Twitter, and Facebook.


Subscribe FREE to AmateurRadio.com's
Amateur Radio Newsletter

 
We never share your e-mail address.

Please support our generous sponsors who make AmateurRadio.com possible:

KB3IFH QSL Cards

Hip Ham Shirts

Georgia Copper

Ham-Cram
Expert Linears

morseDX

Ni4L Antennas

N3ZN Keys

West Mountain
R&L Electronics


Do you like to write?
Interesting project to share?
Helpful tips and ideas for other hams?

Submit an article and we will review it for publication on AmateurRadio.com!

Have a ham radio product or service?
Consider advertising on our site.

Are you a reporter covering ham radio?
Find ham radio experts for your story.

How to Set Up a Ham Radio Blog
Get started in less than 15 minutes!


  • Matt W1MST, Managing Editor




Sign up for our free
Amateur Radio Newsletter

Enter your e-mail address: