AmateurRadio.com

The three VE stations active on 630m CW are looking forward to working you tomorrow (Halloween) evening via the crossband mode during the 630m Activity Night.







In the east, watch for VO1NA. On the west side, watch for VE7BDQ and VE7SL. Here are the transmitting frequencies, times and HF calling frequencies:

• VO1NA - Joe, in Torbay, Newfoundland. Joe will transmit on 477.7 kHz starting at 2130Z Oct 31 and will continue until 0130Z Nov 1. He will listen for callers on 3562 kHz and 7062 kHz.

•  VE7BDQ - John, in Delta, B.C. John will transmit on 474.0 kHz starting at 0100Z and will continue until 1000Z on Nov 1. He will listen for callers on 3536 kHz.

• VE7SL - Steve, on Mayne Island, B.C. I will transmit on 473.0 kHz starting at 0200Z and will continue until 0600Z on Nov 1. I will listen for callers on 3566 kHz and 7066 kHz.

630m propagation conditions have been very good this past week and barring any sudden auroral events, should continue. Unless you are within a few hundred miles of these stations, don't expect signals to be 'loud'. Even when running several hundred watts, antenna's that fit into backyards are not very efficient at radiating all of it! However, from what I have observed, propagation on 630m is very forgiving and has much in common with 160m. Distant signals can sometimes be surprisingly easy to copy when the sun is not up to its tricks!

I have no idea how many stations will be participating on HF but please do not give up should your first few calls not be answered. If conditions appear to be really good, operating hours will probably be extended. Unfortunately Saturday night will probably be out since it is the Sweepstakes CW weekend and will pretty much plug the HF bands, wiping out the calling frequencies.

Don't forget to watch for the Part 5 Experimental stations (WG2's and WD2's) who will be beaconing and working each other on 630m directly. I'm sure they would appreciate your 'heard' reports as well.

Good luck and see you tomorrow.
Steve McDonald, VE7SL, is a regular contributor to AmateurRadio.com and writes from British Columbia, Canada. Contact him at [email protected].

If all goes according to plan, they plan a soft launch of initial production run in a couple weeks, with full scale mass production following shortly thereafter.







For now though you can download the manual at the link below:

http://www.lnrprecision.com/manual/LD5_manual_V1.pdf  


Steve, G1KQH, is a regular contributor to AmateurRadio.com and writes from England. Contact him at [email protected].

By now, you probably realise that I just love WSPR. With quite simple equipment it is possible to be decoded across the planet consistently with real QRP power levels.   I am always on the look-out for new ideas, although until my health improves I am not in a position to build too much myself. See http://www.knology.net/~gmarcus/WSPR/wspr_v4.pdf for an example of a complete 30m WSPR transceiver.

This is NOT a new circuit  – it has been around for some years – and it still needs a PC for the WSPR software. Some TX-only WSPR beacons use microprocessors to generate the WSPR TX messages, thereby freeing up the PC and consuming little power overall. Some sync to GPS to avoid timing issues too.

Roger Lapthorn, G3XBM, is a regular contributor to AmateurRadio.com and writes from Cambridge, England.

We’ve got a bonus episode of AmateurLogic coming your way Saturday Nov. 1 at 1:00 PM CDT, 1700 UTC on www.live.amateurlogic.tv
We will talk with some of the interesting people George met at Pacificon this year.

George Thomas, W5JDX, is co-host of AmateurLogic.TV, an original amateur radio video program hosted by George Thomas (W5JDX), Tommy Martin (N5ZNO), Peter Berrett (VK3PB), and Emile Diodene (KE5QKR). Contact him at [email protected].

From their website:

Airspy is an advanced software defined radio receiver capable of sampling 10MHz of spectrum anywhere between 24MHz and 1.7GHz – and even beyond with extensions. It all started when we needed a good performing receiver that’s still affordable but could not find a good solution in the market, so we designed ours. We believe that as of today, Airspy is the only serious wide band receiver solution that’s high performance and yet affordable.

Some specs:

• Continuous 24 – 1750 MHz RX range with no gaps
• 3.5 dB NF between 42 and 1002 MHz
• Tracking RF filters
• 35dBm IIP3 RF front end
• 12bit ADC @ 20 MSPS (80dB Dynamic Range, 64dB SNR, 10.4 ENOB) – Yeah, size does matter.
• Up to 80 MSPS for custom applications
• Cortex M4F @ up to 204MHz with Multi Core support (dual M0)
• 1.5 ppm high precision, low phase noise clock
• 1 RTC clock (for packet time-stamping)
• External clock input (10 MHz to 100 MHz via MCX connector) – Ideal for phase coherent radios
• 10 MHz panoramic spectrum view with 9MHz alias/image free
• IQ or Real, 16bit fixed or 32bit float output streams
• No IQ imbalance, DC offset or 1/F noise at the center of the spectrum that plagues all the other SDRs
• Extension ports: 16 x SGPIO
• 1 x RF Input (SMA)
• 1 x RF Output (Loopthrough, U-FL)
• 2 x High Speed ADC inputs (up to 80 MSPS, U-FL)
• 4.5v software switched Bias-Tee to power LNA’s and up/down-converters

Thoughts:

From what I’ve read, the big advantage of this over a standard RTL-SDR dongle is much less noise. I haven’t used one, but if it really lives up to their claims the $199 price point is actually pretty reasonable.

http://www.airspy.com / $199

Matt Thomas, W1MST, is the managing editor of AmateurRadio.com. Contact him at [email protected].

Most of you have undoubtedly heard by now that the Antares rocket, launched from NASA's Wallops Island Launch Facility in Virginia, blew up 6 seconds after lift off.


Unfortunately, the rocket was carrying various OSCAR satellites, specifically the GOMX-2 and RACE CubeSats.  Fortunately, it appears that no ground personnel were injured or killed by the mishap.

According to the ARRL:

"The 2U GMX-2 CubeSat was intended to test a de-orbit system designed by Aalborg University in Denmark. Karl Klaus Laursen, OZ2KK, is listed as the “responsible operator” on International Amateur Radio Union frequency coordination documents. The Amateur Radio payload proposed using a 9.6 k MSK data downlink on 437.250 MHz. Also on board was an optical communications experiment from the National University of Singapore. The mission also hoped to flight qualify a new high-speed UHF transceiver and SDR receiver built by an Aalborg University team.

The Radiometer Atmospheric Cubesat Experiment (RACE) CubeSat was a joint project between The Texas Spacecraft Laboratory (TSL) at the University of Texas-Austin and NASA’s Jet Propulsion Laboratory (JPL). It carried a 183 GHz radiometer, a new science instrument designed by JPL. The primary objective of the RACE mission was to collect atmospheric water vapor measurements. The spacecraft was equipped to transmit using GMSK at 38.4 k and CW telemetry on a downlink frequency of 437.525MHz, as coordinated with the IARU. TSL’s Edgar Glenn Lightsey, KE5DDG, was listed in the IARU coordination documents as the responsible operator."

The Antares rocket is a design of the Orbital Space Sciences group. It was on a re-supply mission to the International Space Station and had 5000 pounds of cargo as well as more than two dozen satellites on board. Mankind has been launching payloads into earth orbit for 57 years now. This just goes to show, that as much as this is "rocket science" - that stuff still happens.

On a related note, I was able to visually witness a very nice pass of the ISS this Monday evening.  It was about a 60 or 70 degree pass just around local sunset.  The ISS was very bright and showed up on the horizon right on cue. Wonderful how that works, isn't it?  As I watched it fly overhead, just over the waxing crescent moon, I was reminded of the many passes of RS10/11 and RS12/13 in the 90s. I used to work those LEOs a lot, and had many pleasurable contacts over them.

72 de Larry W2LJ
QRP - When you care to send the very least!


Larry Makoski, W2LJ, is a regular contributor to AmateurRadio.com and writes from New Jersey, USA. Contact him at [email protected].

It is about time I updated one of my more popular posts about my favorite ham radio apps on the iPhone and IPad. As usual, I will focus on free or low cost (less than $5) apps that I am actively using. Some apps have just disappeared from iTunes and new ones have emerged. While this list is completely updated, it is still incomplete, because there are so many apps to choose from.

 

From the Simple Utility Category:

Ham I Am (Author: Storke Brothers, Cost: Free) A handy app that covers some basic amateur radio reference material (Phonetic alphabet, Q Signals, Ham Jargon, Morse Code, RST System, etc.) Although I find the name to be silly, I like the app!
Maidenhead Converter (Author: Donald Hays, Cost: Free) Handy app that displays your grid locator, uses maps and does lat/lon to grid locator conversions.
HamClock (Author: Ben Sinclair, Cost: $0.99) A simple app that displays UTC time and local time. This one reads out to the second.

 

There are quite a few good apps for looking up amateur radio callsigns:

CallBook (Author: Dog Park Software, Cost: $1.99) Simple ham radio callbook lookup with map display.

Call Sign Lookup (Author: Technivations, Cost: $0.99) Another simple ham radio callsign lookup with map display.

 

There are a few repeater directory apps out there and my favorite is:

RepeaterBook (Author: ZBM2 Software, Cost: Free) This app is tied to the RepeaterBook.com web site, works well and is usually up to date.

 

For a mobile logbook (and other tools):

HamLog (Author: Pignology, Cost: $0.99) This app is much more than a logbook because it has a bunch of handy tools including UTC Clock, Callsign Lookup, Prefix list, Band Plans, Grid Calculator, Solar Data, SOTA Watch, Q Signals and much more.

 

To track propagation reports, both HF and VHF:

WaveGuide (Author: Rockwell Schrock, Cost: $2.99) This is an excellent tool for determining HF and VHF propagation conditions at the touch of a finger.

 

If you are an EchoLink user, then you’ll want this app:

EchoLink (Author: Synergenics, Cost: Free) The EchoLink app for the iPhone.

 

There are quite a few APRS apps out there. I tend to use this one because my needs are pretty simple….just track me, baby!

Ham Tracker (Author: Kram, Cost: $2.99) APRS app, works well, uses external maps such as Google and aprs.fi. “Share” feature allows you to send an SMS or email with your location information.

 

Satellite tracking is another useful app for a smartphone:

Space Station Lite (Author: Craig Vosburgh, Cost: Free) A free satellite tracking app for just the International Space Station. It has annoying ads but its free.

ProSat Satellite Tracker (Author: Craig Vosburgh, Cost: $9.99) This app is by the same author as ISS Lite, but is the full-featured “pro” version. Although it is a pricey compared to other apps, I recommend it.

 

For Summits On The Air (SOTA) activity, there are a few apps:

Pocket SOTA (Author: Pignology, Cost: $0.99) A good app for finding SOTA summits, checking spots and accessing other information.

SOTA Goat (Author: Rockwell Schrock, Cost: $4.99) This is a great app for SOTA activity. It works better when offline than Pocket SOTA (which often happens when you are activating a summit).

 

For ham radio license training, I like the HamRadioSchool.com apps. (OK, I am biased here as I contribute to that web site.)

HamRadioSchool Technician (Author: Peak Programming, Cost: $2.99) There are a lot of Technician practice exams out there but this is the best one, especially if you use the HamRadioSchool.com license book.

HamRadioSchool General (Author: Peak Programming, Cost: $2.99) This is the General class practice exam, especially good for use with the HamRadioSchool.com book.

 

Morse Code is always a fun area for software apps:

Morse-It (Author: Francis Bonnin, Cost: $0.99) This app decodes and sends Morse audio. There are fancier apps out there but this one does a lot for $1.

 

Well, that’s my list. Any other suggestions?

– Bob K0NR

The post The Completely Updated Incomplete List of Ham Radio iPhone Apps appeared first on The KØNR Radio Site.

Bob Witte, KØNR, is a regular contributor to AmateurRadio.com and writes from Colorado, USA. Contact him at [email protected].