Indication versus measurement

The nature of a technical hobby gives way to the ‘buying of stuff’. Sometimes this is the tool required to carry out the crux of the hobby, in our case I’m referring to the transceiver. Sometimes this is the tool required to check that the main tool is working correctly, in our case this could any number of tools such as an antenna analyser.

There are also many hams that like to buy the box, or series of boxes and do the minimal amount of testing to ensure safe operation and there are those that will only operate what they have built themselves. Most of us fit on that spectrum. I certainly do, it just varies on what I’m doing.

For longer than I care to admit I have used an antenna analyser that belongs to my local club. It is free to be loaned but I’ve used it more than my fair share of times. I also like to build the odd antenna. This means I measure the length and then cut the wire and check it’s various characteristics and generally cut it again until I’m happy that I have a suitable compromise. Its a really useful tool. I assume its quite accurate because it cost a lot. But do I really need it?

Separating needs from wants is not that easy, partly because what starts out as a want can quite easily become a need. I made a decision recently, I was going to buy my own analyser. But which one? Que the usual looking through specs and performance criteria, guess what happened next. I started with a small requirement for a HF analyser and ended up looking long and hard at analyser >£300. Reflecting on this it becomes easy to bump up the needs because I never really noted down what I actually wanted.

So what did I actually need? In this case I wanted to ensure that I wasn’t going to damage a transceiver and transmit spurious rubbish (as opposed to my usual cw rubbish). So I didn’t really need a tool to measure, I needed a tool to indicate. But ah ha, I still needed to cut the antenna to the right length, so I did need something to measure but did it need to be really accurate?

It turns out it didn’t. It’ll be a good idea to get a rough idea but to 3 decimal places? nope, it just isn’t that important. So I duly purchased a cheapo SARK analyser off ebay for around £30 and it’s allowed me to measure and get the right length(s) (I built a multiband end fed antenna this time) and use a cheapo end fed tuner and the analyser to get the correct swr and impedance for safe and fairly optimised operation.

The lesson learned is that if I don’t set out the requirements first then I’m going to end up spending 10 times on a product that I probably don’t need.

Alex Hill, G7KSE, is a regular contributor to AmateurRadio.com and writes from Cumbria, UK. Contact him at [email protected].

4 Responses to “Indication versus measurement”

Leave a Comment

Subscribe FREE to AmateurRadio.com's
Amateur Radio Newsletter
News, Opinion, Giveaways & More!

E-mail 
Join over 7,000 subscribers!
We never share your e-mail address.



Also available via RSS feed, Twitter, and Facebook.


Subscribe FREE to AmateurRadio.com's
Amateur Radio Newsletter

 
We never share your e-mail address.


Do you like to write?
Interesting project to share?
Helpful tips and ideas for other hams?

Submit an article and we will review it for publication on AmateurRadio.com!

Have a ham radio product or service?
Consider advertising on our site.

Are you a reporter covering ham radio?
Find ham radio experts for your story.

How to Set Up a Ham Radio Blog
Get started in less than 15 minutes!


  • Matt W1MST, Managing Editor




Sign up for our free
Amateur Radio Newsletter

Enter your e-mail address: