Posts Tagged ‘W1GHZ’

W1GHZ 1296 MHz RX working!

I spent about two hours last night assembling the W1GHZ 1296RSU and 1152LO boards from his paper “Multiband Microwave Transverters for the Rover—Simple and Cheap.”  Once again, I trekked over to W3APL beacon site at lunch and put the pair through their paces on RX with the IC-290H as the IF radio.  It worked!  Here’s a clip:

W3APL_B_1296MHz_FSK_mono

One of the interesting things about the 1296-MHz beacon is that it’s FSK, not CW.  You’ll notice this after about 15 seconds when it starts sending its callsign.  The higher pitch tone is “keyed” and the lower is “unkeyed.”  Brian, ND3F, was at the beacon site with us last week to check out a problem (turned out to be a dead power supply fan).  He told us that it’s common for microwave beacons to operate in FSK mode so you always have a carrier to tune across (and swing your antenna across).  Who knew?!

Anyhow, it’s time to start building the other trappings, including enclosures, sequencers, filters, PAs, and T/R switches!  Apart from the PA parts and some connectors, the other components are on-hand and ready.

W1GHZ 903 MHz RX working!

Although I built the W1GHZ 903-MHz transverter and 756-MHz LO boards last winter, I didn’t have time or inclination to test them until this week.  These were purchased as a part of the first (October 2009) group buy orchestrated by W8ISS.  Instead of the INA-10386 MMIC recommended by W1GHZ, the W8ISS kits featured a Sirenza SGA-3586Z MMIC as the LNA, as suggested by the 4s_microwave group.  A better part (with NF < 2 dB), recommended to me by W9SZ, is the the SGA-4586Z, which I used on my 903 board and will use on my 1296 board.  This requires the bias resistor (R3, 51 ohms, on the 1296 board) to be changed to 100 ohms.

Since there is a lot of foliage between me and the W3APL beacon, I took the liberty of carting the transverter and IF rig to the beacon site (sorry no photos) on my lunch break yesterday.  Sure enough, it worked like a charm with the beacon pounding in on 147.0615 MHz.  The nominal beacon frequency is 903.055 MHz, so I don’t know if the difference is in my LO or the not-GPS-locked beacon drifting around.  At any rate, I’m pleased enough to continue the project…

The 1296RSU transverter and 1152-MHz LO boards are on the left in the photo above.  They have not yet been populated, but that’s an evening’s work.


Subscribe FREE to AmateurRadio.com's
Amateur Radio Newsletter

 
We never share your e-mail address.


Do you like to write?
Interesting project to share?
Helpful tips and ideas for other hams?

Submit an article and we will review it for publication on AmateurRadio.com!

Have a ham radio product or service?
Consider advertising on our site.

Are you a reporter covering ham radio?
Find ham radio experts for your story.

How to Set Up a Ham Radio Blog
Get started in less than 15 minutes!


  • Matt W1MST, Managing Editor




Sign up for our free
Amateur Radio Newsletter

Enter your e-mail address: