Posts Tagged ‘Table’
I added a bungee cord on each end to prevent damage from the radio accidentally falling off the table.
The cord does not touch the buttons.
View from the back
All in one, QRP seat, table, umbrella and antenna anchor! The bottle on the table is bug spray! LOL
The table is a cutting board attached to the existing shelf.
The cutting board is bigger than the existing shelf, so I have more room for logging and a sturdy place to attach the antenna!
A bungee cord takes up the slack from the antenna in the wind. In a real world test, I found that one radial is all I need.
I tried an experiment, adding two, then four radials. There was no detectable change in signal level by ear on or the S meter.
One radial did the trick, and 4 radials didn’t improve the signal at all.
Note the guy ropes. This is to hold the chair in place. The golf umbrella is stuffed into a piece of PVC pipe.
The PVC pipe is tied to the chair with cable ties.
Wind and the antenna pulling on the table would easily turn the chair over.
Satisfaction! I can’t wait for the next ham radio outing with my QRP buddies.