AmateurRadio.com

I worked a station last night which was especially rewarding to me. Everyone on the bands this month is aware of the FOC – 75th Anniversary . I have eleven of them in my log book now. I’ve causally worked them “just because they’re on the air” and I love working “Special Event Stations”. Last night (the end of the GMT month) there were so many FOC stations on the air, they were impossible to ignore.

This month, not including the US stations, I’ve worked FOC stations in England, Bermuda, and France; and unexpectedly, I heard this Russian station (R75FOC) in the midst of a big pile up. This particular station was just above the Black Sea of the opposite side of Turkey. I’ve previously worked stations in this area, but never a “Special Event Station” at 5,573 miles.

In a swarm of bees, it’s not  an easy task.

Needless to say, I especially enjoyed “spotting” this station and adding my QRP-3W designation. Personally, I like reading the “remarks” on DX clusters. I know they’re not necessary, but in my case, I just can’t waste the opportunity to let the world know that “QRP” is a viable option for  DX work.

My DX contact into Russia last night, marks my 103rd for the single month of MAY.

I’ve worked the Cuban station (CO8LY) so many times, I actually dropped my power down to one watt. The last few days, I’ve been listening to the 20 meter QRP frequency around “lunch time” and have been working stations regularly.

John Smithson, Jr., N8ZYA, is a regular contributor to AmateurRadio.com and writes from West Virginia, USA. Contact him at [email protected].

I hope I don’t jinx it by writing this, but I think my weather station is now working. Everything is showing the values expected, including the rain which shows 0 mm as we haven’t had any. Trust the Cumbrian weather to not rain when you want it to.

It was actually Olga who got everything working. I had lost patience with it and was all for sending it back. Olga patiently went through the manual (which she found was poorly written) and double-checked everything. She even used my test meter to check the voltage of the newly installed batteries. She found that the rechargeable alkaline batteries supplied for the sensor/transmitter unit were only giving 1.3V each. So she took them out and replaced them with some new Energizer alkaline cells. And everything including the rain sensor started working!

The manual says “Insert 2xAA 1.5V rechargeable batteries into the battery compartment of the remote sensor and immediately afterwards 3xAA alkaline batteries in the base station.” It didn’t say anything about charging them first. If I had provided my own rechargeable batteries I would obviously have charged them first. But as they came shrinkwrapped in the box I assumed they were ready to use. False assumption! It was as simple as that!

Julian Moss, G4ILO, is a regular contributor to AmateurRadio.com and writes from Cumbria, England. Contact him at [email protected].

A few weeks ago, the IPG got some curious email from some ABQ-ians asking if they could play Ingress at the VLA to capture some GPS-based portals. If you’ve never heard of Ingress, think of it as geocaching with a Virtual Reality spin. Check out their website here.

Ingress is played on smart devices, which require data connections to operate. These data connections are fine and dandy unless you’re at the world’s greatest radio observatory; here they aren’t so dandy.

RF-EMS

Below is a screencap of our RF-EMS (Radio Frequency-Environmental Monitoring System) which captured two WiFi access points (the darker blotches) from an RV containing a Verizon 4G hotspot and another router for something else.

Your VLA on WIFI

In the last blog I described the 10′ dish for pinpointing RFI. We also have a (usually) 24/7 monitor that uses some pretty nifty antennas and preamps on a 50′ tower, sending it to an HP 70000 Spectrum Analyzer in a RF-shielded room from which we can record and upload plots like the one above, every day for the past 5+ years. 

RF-EMS Tower and Bunker

The biggest downfall is adequate locating of interfering transmitters. Currently, I’m designing a method which will allow the IPG to quickly and accurately pinpoint people with any kind of transmitter, be it a cell phone, hotspot, or vehicle keyfob (if we wanted to locate such things). My idea is based on multilateriation, which uses multiple receivers around the site which compare arrival times to calculate a four dimensional location. Keeping the bill of materials as low as possible, simplicity, ease-of-use and network integration (without causing RFI itself) a prime focus.

It may be overkill, but it gives me something to do in the free time.

Other Doin’s: Testing out and Debugging the 74 MHz System

When I’m not having free time, this is what I’m doing. A new feature of the Expanded-VLA is observations on the 4 meter band. The current system in place uses these simple crossed dipoles hoisted a few meters below the sub-reflector.

The cross dipoles connect to our receiver, which hooks up to the rack that magically digitizes the signal and turns it into pulses of light which the correlator feeds upon.

One of the problems we face are things broken that don’t have to do with our antennas and receivers. For example, the first test we do to examine the receivers performance is a band pass plot. Often times, we see something like this:

A bad bandpass plot caused by a faulty relay in the T301.

This is ugly! What we want to see is this:

A beautiful bandpass! You can see 4 band on the left, and P-band in the middle with RFI spikes all over.

First we go digging in the LO-IF and FE racks for a place to stick a spectrum analyzer to…

Eric the BAMF next to the LOIF and FE rack. Our culprit is on the left, in the middle of the top rack of modules

And from that we figure its’ this T301 which does the first IF up-conversion from 0-1GHz to 1-2GHz.

We get a new one, stick it in, turn it on and voila, it’s alive!

Sterling Coffey, NØSSC, is a regular contributor to AmateurRadio.com. He is ARRL Youth Editor and an electrical engineering student at Missouri S&T. Contact him at [email protected].

The last time I was out and about with my KX3 my re-chargeable internal batteries let me down.........actually it was user error as I failed to charge them the evening before. Planing is everything they say so the spur of the moment thought of taking my KX3 to the field did not work out so well for me!  The weather forecast has been known to change from rain to sunshine on any given day. To me that is translated as  a non KX3 day thats transformed to a perfect KX3 outing day. To avoid my radio let down I went online and ordered a 12 volt portable 9800Ah Li-ion rechargeable battery pack. It has a wall wart for charging and seems to be a nice little unit. Larry W2LJ has the same pack and it seems to be working well for him. This

My Blue solution

way next time when the internal KX3 batteries TRY to let me down......I will plug in the "Blue solution" As a side note Elecraft offers (which I purchased) an internal battery charger called the KXBC3. This way you can load the KX3 with rechargeable batteries and just plug the KX3 into your power supply and have the KX3 charge the batteries on it's internal timer. Unfortunately this unit does not (as of yet.... but I'm hoping) have the ability to trickle charge the internal batteries. This way it's always ready to go! That is the only downfall to the KXBC3 I have found.
Mike Weir, VE9KK, is a regular contributor to AmateurRadio.com and writes from New Brunswick, Canada. Contact him at [email protected].

My Buddipole Antenna, Configured as a 2 Element Yagi for 6 Meters

The ribbons are to keep me from poking my eyes out on the end of the whips.

Here, I’m trying the antenna out in my driveway before I take it to the beach.

 

 

 

Kx3 QRP Radio 

Six Meter Summer!

This pavilion is my favorite operating spot at Hagen’s Cove. 

It overlooks Dead Man’s Bay, on the Gulf of Mexico in Perry Florida.

I’m going to spend the summer playing around with my Kx3 on 6 meters. The antenna here is a Buddipole, configured as a 2 element Yagi. Its easy to assemble in the field, so I’ll take it to the beach (Hagen’s Cove) and try to make some contacts with it. I’ve been a ham for 22 years but have never done much with 6 meters. This will be a 6 meter summer for me. Join me, I’d love to have a ham radio buddy to share the adventure with.

de AA1IK, 73

Ernest Gregoire, AA1IK, is a regular contributor to AmateurRadio.com and writes from Florida, USA. Contact him at [email protected].

Driving home this evening, I had the second VFO scanning through the 50 or so memories across 29/50/145 and 433MHz, with a few in between!

It doesn’t often stop on 51.51 the 50MHz FM calling frequency, but I heard a loud voice ask someone to move to 51.530. I stopped the scan and tuned there.

The station had an English accent, so I guessed it was a local or an expat. Of course, it turned out to be the latter; EA7/G0WHX. He was a great signal working a G4 I couldn’t hear. There was a little fading, but I listened to the QSO for around 15 minutes.

A great reminder to call on 51.510 a bit more often! You never know who’s listening!

Tim Kirby, G4VXE, is a regular contributor to AmateurRadio.com and writes from Oxfordshire, England. Contact him at [email protected].

http://www.nj2bb.org/museum/index.html

Beginning at 0000Z June 1 through 2359Z June 2, 2013 102 ships will be participating in the Museum Ships Weekend. 

There will be Aircraft Carriers, Battleships, Cruisers, Destroyers, Submarines and more participating on most ham bands.

The details about the ships, frequencies, and certificate information has been listed on the Battleship New Jersey’s NJ2BB.org web site.

This looks like a lot of fun and a good opportunity to teach our kids and grandkids about our amazing maritime history!

Thanks to Ron, AA2RR, for reminding us of this fun weekend opportunity!

Matt Thomas, W1MST, is the managing editor of AmateurRadio.com. Contact him at [email protected].